www.pesukinnas.com

Dani kirjoitti:900RPM minimi on ihan ok, tuskin sitä tarvitsee kun hetken levitykseen käyttää.

Mark (a.k.a. Brazo), moderator at Detailing World kirjoitti: The Zenith Point Technique

Disclaimer: This is only one technique! It works well for me. There are many other techniques I have used which also work but this is the technique I have settled upon after experimenting. There will be numerous other techniques that work as well maybe even better but for now I am happy to stick with this as it gives me the results I want safely and reasonably fast.

It works upon a ‘zenith’ principle as demonstrated below. The rpm of the rotary starts off slow at 600 rpm through to 900rpm and up to a zenith of maybe 1200-1500rpm and then after reaching the zenith point I work back down the scale through 900rpm and finish at 600rpm.

The zenith point (1200-1500rpm+) is the point at which maximum defect removal occurs. At these speeds its fair to say that some defects such as holograms may be imparted so by going back down the scale not only have you removed the original defects but you are now removing any defects imparted by reaching the zenith point. An LSP ready finish can be achieved by all but the harshest polishes. An added bonus is that when using a finer grade polish you are simply adding to the gloss rather than having to remove any defects left by the previous polish.

kikkius kirjoitti:Ei se mahdotonta oo olla tekemättä holoja villalla.

Mänis kirjoitti:Miten te saatte niitä hologrammeja niin helvetisti aikaiseksi? Mä mylläsin rotaryllä ekaa kertaa eläessäni kaverin maximan, enkä saanut siihen edes lampaankarvalla hologrammeja.

kikkius kirjoitti:http://www.detailingworld.co.uk/forum/s ... p?t=128339" onclick="window.open(this.href);return false;